Montage - Prana

Household and semi-industrial series

The recuperator is mounted at the top of the wall bordering the outside. With the help of the diamond drilling method, a hole is drilled outwards, in which the working module is installed with the help of assembly foam or another seal. Only the ventilation grille remains visible: one – inside the room, the other – on the facade.

To ensure normal operation of the ventilation system, it is necessary that the exhaust short pipe (outside) protrudes beyond the wall boundaries by a distance of at least 5 mm to the air collector. The working module is made with a length that corresponds to the wall thickness where the installation is planned.

The ventilation system is connected to a stationary network with a voltage of 220 W and a frequency of 50 Hz.

Industrial series

Industrial series ventilation modules, which are designed for free placement inside the room, are attached to the load-bearing surface with the help of brackets or clamps. Exhaust and intake ducts are connected to the ventilation system according to the design of the ventilation system.

If the work module is intended for wall mounting, a hole of appropriate diameter with a 3-5 degree inclination to the outside must be made in the upper part of the wall bordering the outside. The work module is installed in the hole with the help of assembly foam or other sealant.

In order to ensure the normal operation of the ventilation system, it is necessary for its outlet short pipe (outwards) to protrude beyond the wall boundaries by a distance that ensures free inlet / outlet through the ventilation duct on the housing.